started this project about 6 months ago. It ended up being a bodyoff restoration. New inner and outer rockers on both sides, new dr. floor pan and both cab corners, and one cab support replaced. All the holes were welded shut where the trim was, mirror hole where welded shut. Bed was the biggest hasle mainly because i did not want hardly any filler. Bed was crunched in the back where the bumper had got into it and pushed it in about 3" on both sides. All was pulled and straightened with a few fabricated pieces. All turned out well and straight. have been driving it for a couple of weeks now and in the process of building a 496 to take place of the 307. this will be a good combonation with the NV4500 trans and eaton70 rear diff..